ports裝不上phoenix，請看看輸出結(jié)果幫忙分析

memoza

我剛才用cvsup升級了代碼樹然后再安裝的。

# make install clean
===>;  phoenix-0.5_4 is marked as broken: Phoenix only supports the ports versions of Perl. If you have installed a Perl port, and are getting this message, please make sure you have given the command 'use.perl port'..
===>;  Cleaning for unzip-5.50
===>;  Cleaning for zip-2.3_1
===>;  Cleaning for libiconv-1.8_2
===>;  Cleaning for ORBit-0.5.17
===>;  Cleaning for gettext-0.11.5_1
===>;  Cleaning for glib-1.2.10_8
===>;  Cleaning for gmake-3.80
===>;  Cleaning for imake-4.3.0
===>;  Cleaning for libtool-1.3.4_4
===>;  Cleaning for nspr-4.3
===>;  Cleaning for pkgconfig-0.15.0
===>;  Cleaning for jpeg-6b_1
===>;  Cleaning for lcms-1.09
===>;  Cleaning for libmng-1.0.5
===>;  Cleaning for png-1.2.5_2
===>;  Cleaning for freetype2-2.1.4
===>;  Cleaning for expat-1.95.6_1
===>;  Cleaning for Xft-2.1_7
===>;  Cleaning for fontconfig-2.1.93
===>;  Cleaning for gtk-1.2.10_9
===>;  Cleaning for XFree86-libraries-4.3.0_1
===>;  Cleaning for phoenix-0.5_4
#
我要怎樣解決呢？

statue

phoenix-0.5_4 is marked as broken: Phoenix only supports the ports versions of Perl. If you have installed a Perl port, and are getting this message, please make sure you have given the command 'use.perl port'..

hdcola

需要你在命令行上輸入
use.perl port

kinux

原帖由 "hdcola" 發(fā)表：
需要你在命令行上輸入
use.perl port

說多點好不好, 我也想學一學...

memoza

原帖由 "hdcola" 發(fā)表：
需要你在命令行上輸入
use.perl port

呵呵，我就是不知道在哪里加入，
請寫詳細點好嗎。

hdcola

就在當時的命令行中輸入哪句話就成了。

memoza

大哥，加在哪呀？
你就把它寫出來吧

hdcola

命令行上直接當命令敲進去�。。。�！

quakelee

在安裝了ports里面的perl的情況下，輸入use.perl port

memoza

[quote]原帖由 "hdcola"]命令行上直接當命令敲進去�。。。�！[/quote 發(fā)表：


# perl.use port
perl.use: Command not found.
# perl.use
perl.use: Command not found.
# whereis perl
perl: /usr/bin/perl /usr/share/man/man1/perl.1.gz
#
沒有 /usr/ports/***/perl

實在不知怎么辦才好。

我上次安裝就一點問題都沒有。