linux mcp2515驅動

yu9148

大神們，求助!!!!

      imx31平臺，linux系統  使用兩路spi 外接 2路 mcp2515   
      驅動：內核自帶的mcp251x.c


問題：
spi_imx spi_imx.0: probed
spi_imx spi_imx.1: probed
CAN device driver interface
---------mcp251x_hw_probe-------1----
mcp251x spi0.0: MCP251x didn't enter in conf mode after reset
CANSTAT 0x00 CANCTRL 0x00
mcp251x spi0.0: Probe failed
mcp251x spi0.0: probe failed
---------mcp251x_hw_probe-------1----
mcp251x spi1.1: MCP251x didn't enter in conf mode after reset
CANSTAT 0x00 CANCTRL 0x00
mcp251x spi1.1: Probe failed
mcp251x spi1.1: probe failed

驅動打印SPI發送復位后，不能進入配置模式！  通過示波器測量SPI確實有發送，時鐘，片選正常， 另外測試MCP2515外接無源晶振沒有波形，兩端只有2.4V電壓？？

大神們，這是因?yàn)榫�體沒起振，還是因?yàn)檐浖��?qū)動的問題�。�？？  求助!!!!