請各位老大協助看一下下面的錯誤，分析一下故障原因，謝謝了�。�

sunt

Jun  6 22:00:26 backup scsi: [ID 365881 kern.info] /pci@1f,2000/scsi@1,1 (glm3):\r\nJun  6 22:00:26 backup  Cmd (0x15dd20 dump for Target 1 Lun 0:\r\nJun  6 22:00:26 backup scsi: [ID 365881 kern.info] /pci@1f,2000/scsi@1,1 (glm3):\r\nJun  6 22:00:26 backup          cdb=[ 0xa 0x0 0x4 0x0 0x0 0x0 ]\r\nJun  6 22:00:26 backup scsi: [ID 365881 kern.info] /pci@1f,2000/scsi@1,1 (glm3):\r\nJun  6 22:00:26 backup  pkt_flags=0x0 pkt_statistics=0x61 pkt_state=0x7\r\nJun  6 22:00:26 backup scsi: [ID 365881 kern.info] /pci@1f,2000/scsi@1,1 (glm3):\r\nJun  6 22:00:26 backup  pkt_scbp=0x0 cmd_flags=0x18e1\r\nJun  6 22:00:26 backup scsi: [ID 107833 kern.warning] WARNING: /pci@1f,2000/scsi@1,1 (glm3):\r\nJun  6 22:00:26 backup  Disconnected command timeout for Target 1.0\r\nJun  6 22:00:26 backup glm: [ID 160360 kern.warning] WARNING: ID[SUNWpd.glm.cmd_timeout.6016]\r\nJun  6 22:00:26 backup scsi: [ID 107833 kern.warning] WARNING: /pci@1f,2000/scsi@1,1/st@1,0 (st22):\r\nJun  6 22:00:26 backup  SCSI transport failed: reason \'timeout\': giving up\r\n\r\n在備份的過程中，時間一旦較長（1小時左右）的話，就報上面的錯誤，導致備份停止，請各位老大協助定位一下原因，謝謝了�。�\r\n系統：solaris8 \r\n應用：nbu+catalog\r\n硬件：sun420 + L180 (dlt7000)

sunt

出現上述故障后，再不做任何改動的前提下，我再次手動備份，還不影響正常進行，但是時間長了又會出現上述故障！！\r\n所以，現在也無法定位是軟件或硬件問題

kouyy

關注!我也遇到個問題.當時有兩個文件系統滿了,有報錯,不知道是什么原因\r\nJun 16 09:18:44 test scsi: [ID 107833 kern.warning] WARNING: /pci@8,700000/scsi@1/st@5,0 (st5):\r\nJun 16 09:18:44 test Error for Command: load/start/stop  Error Level: Fatal\r\nJun 16 09:18:44 test scsi: [ID 107833 kern.notice]        Requested Block: 0         Error Block: 0\r\nJun 16 09:18:44 test scsi: [ID 107833 kern.notice]        Vendor: HP          Serial Number:    9   $DR-1\r\nJun 16 09:18:44 test scsi: [ID 107833 kern.notice]        Sense Key: Hardware Error\r\nJun 16 09:18:44 test scsi: [ID 107833 kern.notice]     ASC: 0x44 (internal target failure), ASCQ: 0x0, FRU: 0x1\r\nJun 16 09:29:57 test scsi: [ID 107833 kern.warning] WARNING: /pci@8,700000/scsi@1/st@5,0 (st5):\r\nJun 16 09:29:57 test Periodic head cleaning required

Johnunix

如果SCSI線的連接沒問題的話，多數是帶機的問題。曾經遇到L9就有類似的現象，換帶庫就正常了。