fmdump -m 如下：
cps@sac1>fmdump -m
SUNW-MSG-ID: SUNOS-8000-FU, TYPE: Defect, VER: 1, SEVERITY: Major
EVENT-TIME: Mon Oct 10 11:27:50 GMT 2011
PLATFORM: PowerEdge-R310, CSN: CX2F43X, HOSTNAME: sac1
SOURCE: eft, REV: 1.16
EVENT-ID: d9f3d893-497d-6aa0-f698-fe0358d5b1d3
DESC: The diagnosis engine encountered telemetry for which it was unable to perf
orm a diagnosis. Refer to http://sun.com/msg/SUNOS-8000-FU for more information
.
AUTO-RESPONSE: Error reports have been logged for examination by Sun.
IMPACT: Automated diagnosis and response for these events will not occur.
REC-ACTION: Ensure that the latest Solaris Kernel and Predictive Self-Healing (P
SH) patches are installed.
SUNW-MSG-ID: PCIEX-8000-KP, TYPE: Fault, VER: 1, SEVERITY: Major
EVENT-TIME: Thu Dec 22 18:02:22 GMT 2011
PLATFORM: PowerEdge-R310, CSN: CX2F43X, HOSTNAME: sac1
SOURCE: eft, REV: 1.16
EVENT-ID: f06c9a2b-bc38-efae-c624-aecd1601ae82
DESC: Too many recovered bus errors have been detected, which indicates a proble
m with the specified bus or with the specified transmitting device. This may deg
rade into an unrecoverable fault.
Refer to http://sun.com/msg/PCIEX-8000-KP for more information.
AUTO-RESPONSE: One or more device instances may be disabled
IMPACT: Loss of services provided by the device instances associated with this f
ault
REC-ACTION: If a plug-in card is involved check for badly-seated cards or bent p
ins. Otherwise schedule a repair procedure to replace the affected device. Use
fmadm faulty to identify the device or contact Sun for support.作者: Aaron811218 時間: 2012-02-21 07:03
報錯顯示的是PCI-E設備有問題
Problem in: hc://:product-id=PowerEdge-R310:server-id=sac1:chassis-id=CX
2F43X/motherboard=0/hostbridge=1/pciexrc=1/pciexbus=4/pciexdev=0/pciexfn=1
Affects: dev:////pci@0,0/pci8086,d138@3/pci1462,1833@0,1
FRU: hc://:product-id=PowerEdge-R310:server-id=sac1:chassis-id=CX
2F43X/motherboard=0/hostbridge=1/pciexrc=1/pciexbus=4/pciexdev=0
Location: PCIE1
查看一下DELL服務器PCI-E1號插槽插了什么設備，試著重新插拔一下，如果故障依舊，需要更換這個設備。
如果插槽上沒有任何設備，主板問題的可能性較大。作者: doging 時間: 2012-02-21 09:40
報了這么多錯，直接更換PCIE1槽位設備吧作者: windlzm 時間: 2012-02-21 10:22
謝謝doging，Aaron811218；萬分感謝；
現場機箱打開后，pci插槽部分只有內存條，怎樣在機箱里看到某個插槽是PCIE1，它有標示么？作者: windlzm 時間: 2012-02-21 13:02
Aaron811218 ,謝謝你；我到現場了，打開機箱查看過了，pcie1插槽內沒有插件；那是主板問題了么？
另現有dell服務器我裝的是solaris，如裝linux系統該問題能緩解么？作者: windlzm 時間: 2012-02-21 13:08
還有我做過實驗，如不插網線；errlog文件就不會增長；現場也出現過服務器網絡通信異常，切該現象出現時候，errlog文件把var分區填滿；
服務器網卡我查看了下是主板集成網卡。。。那是不是最大的懷疑對象就是主板集成網卡出錯了？作者: Aaron811218 時間: 2012-02-22 01:23
主板問題的可能性非常大。solairs 10的自我診斷功能很強大，如果換成linux，可能會正常運行。因為兩種操作系統的診斷機制是不同的。