標題: 自問自答 usysfault用法 [打印本頁] 作者: beking1627 時間: 2007-12-27 09:26 標題: 自問自答 usysfault用法 #/usr/lpp/diagnostics/bin/usysfault -h
usage: usysfault [-s normal ] [-l location code | -d device name]
usysfault [-t]
#man usysfault
Manual entry for usysfault not found or not installed.
#
-s normal的用法大家都知道,想問問其他參數的含義和用法,謝謝!
[ 本帖最后由 beking1627 于 2007-12-28 10:36 編輯 ]作者: beking1627 時間: 2007-12-28 09:38
沒人賜教么?
誰的機器安裝了man手冊,幫咱man一下也行啊。作者: beking1627 時間: 2007-12-28 10:06 標題: 自問自答吧,哈哈。 Flag
Description
-s normal
Sets the fault indicator to the normal state.
-l location code
Identifies the resource by physical location code.
-d device name
Identifies the resource by device name.
-t
Displays a list of all supported fault indicators by physical location codes.作者: beking1627 時間: 2007-12-28 10:09
When the command is used without the -s flag, the current state of the indicator is displayed as normal or fault.
When the command is used without the -l or -d flag, the System Attention Indicator is used.
Use the -l or -d flags only in systems that have more than one fault indicator.作者: yuio654 時間: 2010-04-28 17:21
團長